Non Slip Ladder Rung Covers

Why Choose RungGrip Anti Slip Ladder Rung Covers?

• Our RungGrip comes in a variety of lengths and sizes to fit most ladder rungs. We also offer a free cut to size service if our stock sizes aren't suitable. 
• Anti slip - with a PTV value of 59 when dry and 55 when wet, our RungGrip provides the perfect solution to problems and injuries caused by slippery ladders.
• Durable and chemical resistant - constructed from fibreglass, our RungGrip will resist chemical attack from corrosive fluids transferred from the sole of the boot. Also resistant to contact with food, oil and grease.
• High visibility - our RungGrip make ladders more visible in areas where light is limited.
• Easy and quick to apply, just adhere down with 3M 5200 Marine Adhesive Sealant.

Case Study

• Hafan Pwllheli Case Study
• British Petroleum Case Study

How to Apply

• RungGrip is bonded to the existing steel rung using 3M 5200 Marine Adhesive Sealant.

Preparation

• Ensure the ladder rung surfaces are clean, dry and free from loose and friable material.
• Dry fit all RungGrip profiles to ensure they fit freely and that they sit flat down on the surface. If required, RungGrip can be trimmed on site to suit, ideally using a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade.
• Please ensure that goggles and gloves are worn at all times when any form of cutting is involved.

Application

• Using a suitable abrader, rub down the substrate to give an adequate ‘key’.
• Turn the RungGrip profile upside down and apply a 6mm bead of the 3M 5200 Marine Adhesive Sealant around the inside of the RungGrip profiles. Then simply push the RungGrip profile over the rung and twist to ensure the adhesive coats the rung.
• Level the RungGrip profile so that the top surface is completely horizontal. A spirit level can be used if required.
• Important: Allow a minimum of 24 hours for the adhesive to cure. Test that the RungGrip profile is completely bonded before putting the ladder back into service.