Safety Glow Stair Nosing

• Glow in the dark technology - our Safety Glow Stair Nosings Glow in the Dark for between 3 - 4 hours.
• Quick installation - drill down with mechanical fixings and you're good to go. Minimal downtime and can be walked on immediately.
• The contrasted nosing also makes them Building Regulation and Disability Discrimination Act compliant.
• Installs over virtually any substrate.
  
• Lengths: 750mm, 1000mm, 1500mm, 2000mm or 3000mm
• Profile: 70mm x 30mm
• Thickness: 3mm with grit

How to Install

• You can install our Edge Glow Anti Slip GRP Stair Nosing easily and quickly with our Glow Anti Slip GRP Stair Nosing Fixing Kits. 1 fixing kit covers 5 x 3000mm of stair nosing.

Preparation

• Ensure that the area is clean, dry and free from loose and friable material. Any “dished” or damaged surface areas should be patch repaired to provide a reasonably flat and consistent surface. You can patch repair concrete with our Step Edge Repair.
• Dry fit stair nosings to ensure they fit freely and that they sit flat down on the surface. If required, can be trimmed on site to suit, ideally using a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade.
• Please ensure that goggles and gloves are worn at all times when any form of cutting is involved.

Fixing Kit Application

• Glow In Dark Apply a 6mm bead (this may need to be increased dependant on the substrate conditions) of the high strength gap filling adhesive around the periphery of the underside of the stair nosings approx. 15mm in from the edges. If you are fixing your nosing to carpet or similar material - you can skip the adhesive section of the application. The adhesive is best applied using a skeleton gun.
• Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive (depending on the size of the bead, this will elevate the sheet by approximately 1-1.5mm). A firm bond will be achieved in about one hour under normal circumstances and conditions.
• Drill two holes on each side of the stair nosing, the first approximately 15mm in from each edge. For larger nosings, it may be necessary to have further fixing points in the centre of the tread. Pre-drilling the holes before drilling into the substrate is recommended.