Heavy Duty Non Slip GRP Stair Nosings

• Stair Nosing Quick installation - drill down with mechanical fixings and you're good to go. Minimal downtime and can be walked on immediately.
• Durable and tough - made from fibreglass GRP through the pultrusion process, our Standard Nosings are resistant to swelling, stretching or warping over a wide range of temperatures and physical stresses.
• Anti slip top surface - our silicon quartz grit provides excellent anti slip properties providing increased safety on steps and stairs and the high contrasting colour aids visibility. The chamfered back edge also provides additional security to your stairs.
• Their 55mm contrasted nosing also makes them Building Regulation and Disability Discrimination Act compliant.
• Installs over virtually any substrate.
• 5 Year Guarantee against breakage.

How to Install

• You can install our EdgeGrip Standard Anti Slip GRP Stair Nosing easily and quickly with our EdgeGrip Standard Anti Slip GRP Stair Nosing Fixing Kits. 1 fixing kit covers 5 x 3000mm of stair nosing.

Preparation

• For Stair Nosing Ensure that the area is clean, dry and free from loose and friable material. Any “dished” or damaged surface areas should be patch repaired to provide a reasonably flat and consistent surface. You can patch repair concrete with our Step Edge Repair.
• Dry fit stair nosings to ensure they fit freely and that they sit flat down on the surface. If required, can be trimmed on site to suit, ideally using a skill saw with a 4mm diamond blade or an angle grinder with a 1mm blade.
• Please ensure that goggles and gloves are worn at all times when any form of cutting is involved.

Fixing Kit Application

• Apply an 6mm bead (this may need to be increased dependant on the substrate conditions) of the high strength gap filling adhesive around the periphery of the underside of the stair nosings approx. 15mm in from the edges. If you are fixing your nosing to carpet or similar material - you can skip the adhesive section of application. The adhesive is best applied using a skeleton gun.
• Immediately press the panel firmly to the substrate to ensure adequate transfer of adhesive (depending on the size of the bead, this will elevate the sheet by approximately 1-1.5mm). A firm bond will be achieved in about one hour under normal circumstances and conditions.
• Drill two holes on each side of the top surface in the centre (grit surface), approximately 50mm in from the side, then approximately every 400-500mm. Dependant on the substrate it may be necessary to increase or decrease this spacing. For larger nosings, it may be necessary to have further fixing points in the centre of the tread. Pre-drilling the holes before drilling into the substrate is recommended.